Welcome Back! Please login to get access to restricted area or for shopping.

The cart is empty
  1. massimo
  2. Main Forum
  3. Sunday, 04 October 2020
  4.  Subscribe via email
Hi Marcin,
please, your help is needed.
I am going to connect Skalarki TQ to PSU.
I know that TQ needs three PSU:
24V 2.5A PSU (for TQ stepper motor),
12V 60W PSU (for all control boards),
15V 60W PSU (for back light).
Six wires come out from the green connector. On pluging the connector in its base, as you know, the standard order from the left side to the right side is the following: blu - black - brown - black - black - green.
I cannot understand which is the sequence to connect these wires to the different PSU and specifically which wire shall be connect to each PSU (I know that black is - polarity always).
Many thanks in advance.
My best regards
Massimo
Comment
There are no comments made yet.
Accepted Answer Pending Moderation
0
Votes
Undo
Hi
Black is always Ground
Black/Blue is 24V
Black/Green is BKLT (in your case 15V)
Black/Brown is PSU 12V
Attachments (1)
Marcin
– – – – – – – – – – – – – – – – – – – – – – – – – – – –
SKALARKI electronics Ltd
Comment
There are no comments made yet.
  1. more than a month ago
  2. Main Forum
  3. # 1
Accepted Answer Pending Moderation
0
Votes
Undo
Many thanks
Massimo
Comment
There are no comments made yet.
  1. more than a month ago
  2. Main Forum
  3. # 2
  • Page :
  • 1


There are no replies made for this post yet.
Be one of the first to reply to this post!